Connections; Pedal In; Aux In; Line Out - Technics SX-PX554 Service Manual

www.freeservicemanuals.info
(On the back of piano)

LINE OUT

R
R + L
/

PEDAL IN

Connect the cord from the included stand to this
terminal.
AUX IN (input level 0.5 Vrms, 6 k )
Other instruments such as a rhythm machine or
sound module can be connected to the piano so
that the sound is output from the piano. To re-
ceive monaural sound, connect instruments to
the R/R+L terminal.
LINE OUT (output level 1.5 Vrms, 600
By plugging into a high-power amplifier, the
sound can be reproduced at high volume. (Use
the R/R+L terminal when outputting monaural
sound. However, there are some cases where
the sound quality may deteriorate depending on
the sound.)
HEADPHONES (phones) 2
(Beneath the keyboard, on the left side)
For silent practice headphones may be used.
When plugged in, the speaker system is automa-
tically switched off, and sound is heard only
through the headphones.
phones

AUX IN

L R L
R + L
/
)
World of free manuals
09/08/2012
MIDI
OUT IN
PEDAL IN
COMPUTER
By connecting this terminal to the serial port of
a computer, performance data can be ex-
changed. Use the switch to select the type of
computer.
Be sure that the power to this instrument is
turned off when connecting to a computer
or when changing the switch setting.
The new switch setting will be effective
when the power is turned on again.
Caution: Failure to turn off the power before
changing the switch setting may result in
malfunction.
When no computer is connected, or when a
MIDI interface is used, the switch should be
set to MIDI.
Connection to a Macintosh series computer
Use an ACCESSORY CABLE (SZ-JJAP1, sold
separately) to connect the COMPUTER terminal
of this instrument to the modem port or printer
port of a Macintosh Series computer. Set the
switch to MAC.
Set the MIDI interface clock of the Macin-
tosh software to 1 MHz.
Do not remove the core at either end of the
cable.
Connection to a PC
Use an ACCESSORY CABLE (SZ-JJAT1, sold
separately) to connect the COMPUTER terminal
of this instrument to the RS232C terminal of a
PC. Set the switch to PC2.
The MIDI driver included with the cable
should be installed in the computer. (Refer
to the manual accompanying the cable.)
Do not remove the core at either end of the
cable.
* All product and company names are trademarks or regis-
tered trademarks of their respective owners.
www.nostatech.nl
COMPUTER
PC2
PC1
MIDI MAC