Black & Decker BDCHD18 Manual
  1. Manuals
  2. Brands
  3. Black & Decker Manuals
  4. Drill
  5. BDCHD18
  6. Manual

Black & Decker BDCHD18 Manual

Hide thumbs Also See for BDCHD18:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

See also: Instruction Manual
2
1
8
www.blackanddecker.com.au
www.blackanddecker.co.nz
4
3
6
9
5
7
BDCHD18

Advertisement

Table of Contents
loading

Related Manuals for Black & Decker BDCHD18

Summary of Contents for Black & Decker BDCHD18

  • Page 1 BDCHD18 www.blackanddecker.com.au www.blackanddecker.co.nz...
  • Page 2 ENGLISH (Original instructions)

  • Page 3: Intended Use

    3. Personal safety a. Stay alert, watch what you are doing and use common Your BLACK+DECKER BDCHD18 - Drill, has been designed sense when operating a power tool. Do not use a for screwdriving applications and for drilling in wood, metal power tool while you are tired or under the influence and masonary.
  • Page 4 ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or tool "live" and could give the operator an electric shock. Hold power tool by insulated gripping surfaces, when binding of moving parts, breakage of parts and any performing an operation where the fastener may other condition that may affect the power tools contact hidden wiring.
  • Page 5 (Original instructions) ENGLISH Warning! The vibration emission value during actual use of Electrical safety the power tool can differ from the declared value depending Your charger is double insulated; therefore no on the ways in which the tool is used. The vibration level may earth wire is required.

  • Page 6: Hints For Optimum Use

    ENGLISH (Original instructions) Installing and removing the battery pack from the Grasp the rear half of the chuck (4) with one hand and use tool (fig. B) your other hand to rotate the front half in the counterclock- wise direction, as viewed from the chuck end. Warning! Make certain the lock-off button is engaged to Insert the bit or other accessory fully into the chuck, and prevent switch actuation before removing or installing battery.

  • Page 7: Maintenance

    Always use the correct type and size of screwdriver bit. If screws are difficult to tighten, try applying a small Technical data amount of washing liquid or soap as a lubricant. Always hold the tool and screwdriver bit in a straight line BDCHD18 with the screw Voltage Troubleshooting 0-360/0-1400...
  • Page 8 ENGLISH (Original instructions) Australia & New Zealand 90621477 Charger Stanley Black & Decker Input voltage www.blackanddecker.com.au Output voltage www.blackanddecker.co.nz Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ) Current Approx. charge time Hours 90590289-02 Charger Input voltage Output voltage Current 3 - 5 Approx.

Table of Contents