Others; Part Names - Pioneer SC-LX501 Basic Manual

> Before start > Hookup

Others

Listening To the Radio
a
1. Press TUNER (a) on the remote controller repeatedly to
select either "AM" or "FM" on the display.
2. Press MODE (c) on the remote controller, so that the
"TunMode: Auto" is displayed on the display.
b
3. When you press the  /  cursor (b) buttons on the
remote controller, automatic tuning starts, and searching
stops when a station is found. When tuned into a radio
station, the "TUNED" indicator on the display lights.
You can preset up to 40 stations.
1. Tune into the AM/FM radio station you want to register.
2. Press +Fav (d) on the remote controller so that the
preset number on the display flashes.
3. While the preset number is flashing (about 8 seconds),
c
repeatedly press the  /  cursor (b) buttons on the
d remote controller to select a number between 1 and 40.
4. Press +Fav (d) again on the remote controller to register
e
the station. When registered, the preset number stops
flashing. To select a preset radio station, press the  /
 cursor (b) buttons on the remote controller.
0 To delete a preset station, press the  /  cursor (b)
buttons on the remote controller to select the preset
number you want to delete, press +Fav (d) on the
remote controller and then press CLEAR (e) while the
preset number is flashing. When deleted, the number on
the display goes off.
Frequency step setting
Press the
"System Setup" – "Miscellaneous" – "Tuner" – "AM/FM
Frequency Step" or "AM Frequency Step" and select the
frequency step for your area. Note that when this setting is
changed, all radio presets are deleted.
> Setup > Playback
button on the remote controller to select
> Part Names
Multi-zone
d
Play
e
1. While holding down MODE (a) on the remote controller,
press ZONE 2 (b) for 3 or more seconds until the remote
indicator blinks twice.
0 The remote controller switches to the mode for
controlling ZONE 2.
To return the remote controller to main room control
mode: While holding down MODE (a) on the remote
controller, press MAIN (c) for 3 seconds or more until the
remote indicator flashes once.
b
2. Point the remote controller at the main unit and press Í
(d).
c
"Z2" lights on the main unit display.
a
3. Press the input selector button (e) of the input to be
played in the separate room. On the main unit, after
pressing ZONE CONTROL, within 8 seconds turn the
INPUT SELECTOR dial to select the input to be played
in the separate room.
0 You can only select the same inputs for the main
room and separate room with the "NET" or
"BLUETOOTH", or "USB" input selector. If you have
"NET" selected in the main room and then select
"USB" in the separate room, the main room also
switches to "USB". You cannot select different
stations for the main room and separate room with
the AM/FM radio.
0 DSD and Dolby TrueHD audio signals are not output
to ZONE 2 when selected with the "NET", "USB"
input selector.
4. To adjust the volume on the power amplifier in the
separate room or the Zone Speaker, adjust with VOL+/–
on the remote controller. To control on the main unit,
press ZONE CONTROL and within 8 seconds, adjust
En
25