Fitting The Lens Cap; The Grip Belt; Using The Lcd Monitor - Panasonic NV-GS25GN Operating Instructions Manual

(38)
Shoulder strap fixture
1
2
≥Put the strap through the fixture 1 and through
the stopper 2 so it will not come off. Extend
part 3 by at least 2 cm.
≥Fit the other end of the belt similarly.

Fitting the lens cap

Fit the lens cap to protect the surface of the lens.
1
The lens cap and lens cap cord comes
preattached to the grip belt.
Pass the end of the lens cap cord through
the attached eye on the lens cap. Then pass
the lens cap through the loop made by itself
and pull tight.
≥When not using the Lens Cap, pull the Lens
Cap Cord in the direction of the arrow. 1
≥When you are not recording, be sure to cover
the Lens with the Lens Cap for protection. 2
1
≥When you remove the lens cap, press the knobs
firmly.
6
LSQT0893
Before using

The grip belt

Adjust the belt length so it fits your hand.
1
3
1 Flip the belt.
2 Adjust the length.
3 Fix the belt.

Using the LCD monitor

You can record the image while viewing it on the
LCD monitor opened.
1
2
2
≥The brightness and colour level of the LCD
monitor can be adjusted from the menu.
≥If it is forcibly opened or rotated, the camera
may be damaged or fail.
≥Check that the card slot cover is closed.
≥When the LCD monitor is rotated by 180o
towards the lens (when recording yourself), the
LCD monitor and the viewfinder will be
simultaneously activated.
Adjust the belt length.
Put a finger on the LCD monitor open part
and pull the LCD monitor out in the
direction of the arrow.
≥The viewfinder will go off.
≥It can open up to 90o.
Adjust the angle of the LCD monitor as you
prefer.
1 180o
≥It can rotate up to 180o 1 towards the lens or
90o 2 towards the viewfinder.
2
1 3
2 90o