Asus Z170 PRO GAMING/AURA User Manual page 29

4. ATX power connectors (24-pin EATXPWR, 8-pin ATX12V)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
Z170 PRO GAMING/AURA ATX power connectors
• For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a
minimum power of 350 W.
• DO NOT forget to connect the 4-pin/8-pin ATX +12V power plug. Otherwise, the
system will not boot up.
• We recommend that you use a PSU with higher power output when configuring a
system with more power-consuming devices or when you intend to install additional
devices. The system may become unstable or may not boot up if the power is
inadequate.
• If you are uncertain about the minimum power supply requirement for your system,
refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details.
5. Thermal sensor connector (2-pin T_SENSOR)
This connector is for the thermistor cable that allows you to monitor the temperature of
your motherboard's critical components and connected devices.
Z170 PRO GAMING/AURA T_SENSOR connector
ASUS Z170 PRO GAMING/AURA
A
A
EATX12V
PIN 1
B
+5V Standby
T_SENSOR
GND
PIN 1
SENSOR IN
B
EATXPWR
+3 Volts GND
+12 Volts +5 Volts
+12 Volts +5 Volts
+5 Volts
Power OK -5 Volts
GND GND
+5 Volts GND
GND GND
+5 Volts PSON#
GND GND
+3 Volts -12 Volts
+3 Volts +3 Volts
PIN 1
The thermistor cable is purchased
separately.
1-19