Entertainment Systems - Radio/Cd - GMC 2005 Yukon Owner's Manual

Hide thumbs Also See for 2005 Yukon:
Table of Contents

Advertisement

ture, airflow and fan speed for the rear
seat passengers.
To operate the rear climate control sys-
tem from the front seat position, use the
driver overhead controls (shown above).
To use the rear seat controls, the front
fan control knob must be in the AUX
position.
On the rear seat control panel, press the
mode button (
) and select AUTO if
you want the system to regulate airflow.
Rear Air Conditioning Only Systems
Rear air conditioning only systems have
two fan speed selectors: one in the
overhead console and the other in the
second row seat headliner. To use the
rear seat controls, the front control must
be in the AUX position.
See Section 3 of your Owner Manual.
Entertainment Systems —
Radio/CD
Set the time on radios without a
Radio Data System (RDS)
• Press and hold the HR or MIN arrow
for two seconds.
• Press the HR (down) arrow until the
correct hour appears on the display.
• Press and hold the MIN (up) arrow
until the correct minute appears on
the display.
Set the time on radios with a Radio
Data System (RDS)
Your radio may have a button marked
"H" or "HR" to represent hours and an
"M" or "MIN" to represent minutes.
• Press and hold the hour button until
the correct hour appears on the
display.
• Press and hold the minute button
until the correct minute appears on
the display.
Note: The time may be set with the
ignition on or off.
Program radio station presets
• Turn the radio on.
• Press BAND to select the band
(AM, FM1/FM2/XM1/XM2).
• Use the seek button or tune knob to
tune in the desired station.
• Press AUTO EQ or AUTO TONE (as
applicable to your radio) to select the
equalization that best suits the type of
station selected.
• Press and hold one of the six num-
bered buttons until a beep sounds;
release the button.
• Repeat these steps for each station
preset, using a different numbered
button for each station.
Access one of the two available XM
Satellite Radio bands (if equipped)
• Press the BAND button until XM1 or
XM2 appears on the display. (Note:
Requires subscription to XM Radio.)
7

Advertisement

Table of Contents
loading

Table of Contents