Panasonic AJ-HPX2700G Operating Instructions Manual page 160

Item Message
HDD CAPACITY
FULL!
TOO MANY
PARTITIONS!
HDD
DISCONNECTED!
CANNOT FORMAT!
TOO MANY
TARGETS!
UNKNOWN DEVICE
CONNECTED!
CANNOT ACCESS
TARGET!
HDD
(USB HOST
CANNOT
mode)
RECOGNIZE HDD!
CANNOT ACCESS
CARD!
MISMATCH
COMPONENT!
P2 CARD IS
UNFORMATTED!
CARD IS EMPTY!
CANNOT COPY!
VERIFICATION
FAILED!
PLEASE FORMAT P2
CARD!
160
Maintenance and Inspections: Warning System
Description
Not enough space left on the hard disk.
There are too many partitions.
The unit is not connected to a hard disk.
The hard disk cannot be initialized.
Multiple devices are connected.
The connected DVD drive is not compatible.
An error occurred during hard disk access.
The destination target cannot be properly
recognized.
An error occurred during P2 card access.
Copying is not possible since the model number
of the destination card does not match that of the
source card.
The P2 card is not formatted.
The P2 card selected for copying is empty.
The compare check after copying failed.
This warning indicates that data could not be
imported from a hard disk to a P2 card because
the P2 card contained recorded data.
Measure
There is not enough space on the connected
hard disk. Use a new hard disk or formatted hard
disk.
Hard disks can handle up to 23 partitions. Use a
new hard disk or formatted hard disk.
Reconnect the USB cable. If the hard disk does
not operate normally, turn it off and turn it back on
again.
Connect another hard disk drive.
Disconnect devices, turn off the unit and turn it
back on again.
Disconnect devices, turn off the unit and turn it
back on again.
Check hard disk status and connection.
Reboot the hard disk or connect a different hard
disk.
Check P2 card.
Use a P2 card with the same model number or
import video in clip units.
Use a formatted P2 card.
Copying is not performed since the card is empty.
Copy the data again.
You cannot copy to a P2 card that contains data.
Format the card on a P2 device and copy again.