Eq Modes - American Audio VMS5.0 User Manual And Reference Manual

Eq mOdES

The EQ for the USB audio can work in two different modes, Pre & Post EQ. These EQ modes can
work in both 4 out and 8 out interface modes that are described on pages 18-19.
In Pre EQ the USB audio signal is affected by the VMS5.0 EQ. Pre EQ is the default EQ. In Pre EQ
mode the ASIO Driver will list the VMS5.0 device number, the first number in the sequence will be a
"0". Please see the window below.
***Beware that mapping the MIDI on the EQ knobs in this mode will cause your audio to process the
EQ from the software and VMS5.0 EQ.
Post EQ is for users who prefer using the EQ from their software. To toggle the post EQ mode
on and off; before powering up the VMS5.0, press and hold the pfl cue (4) on the 4th chan-
nel MIDILOG and then power "ON" the unit. Release the button, your computer may reinstall the
VMS5.0 as a new device, please allow 10-20 seconds for the change to take place. Confirm the EQ
change by checking the ASIO Driver configuration. The first number in the sequence will be a "1" in
this mode. Please see the window below.
Make sure you are using software where you can map the MIDI from the EQ and that the EQ has
been mapped when using this mode.
American Audio - www.americanaudio.us - VMS5.0 Instruction Manual Page 17
© ®