Changing The Exhaust Direction - Hitachi NV 65AN Instruction And Safety Manual

English
(3) Single sequential operation (Trigger fi re)
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Pull the trigger rapidly and fi rmly.
1 Position the nail outlet on the workpiece with
fi nger off the trigger.
2 Depress the push lever fi rmly until it is completely
depressed.
3 Pull the trigger to drive a nail.
4 Remove fi nger from the trigger.
To continue nailing in a separate location, move the nailer
along the wood, repeating steps 1 – 4 as required.
2
Push Lever
● Keep your fi nger off the trigger except during
fastening operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This Hitachi nailer may
bounce from the recoil of driving a fastener
and unwanted subsequent fastener may be
driven, possibly causing injury.
● Some types of loaded nails can spark out of
the muzzle during a nail driving operation.
Exercise caution!
The SINGLE SEQUENTIAL ACTUATION MECHANISM
is for use where precision fastener placement is desired.
The SINGLE SEQUENTIAL ACTUATION MECHANISM
may reduce the possibility of bodily injury to you or others
in the work area compared to the CONTACT ACTUATION
MECHANISM. This is because it is less likely to drive
16
WARNING
Trigger
3
WARNING
an unwanted nail if you keep the trigger pulled and
accidentally bump the push lever against yourself or
others.
The SINGLE SEQUENTIAL ACTUATION MECHANISM
may also reduce the speed of operation compared
to the CONTACT ACTUATION MECHANISM. The
SINGLE SEQUENTIAL ACTUATION MECHANISM is
recommended to inexperienced users.
NOTE:
● If all warnings and instructions are followed,
safe operation is possible with two systems:
CONTACT ACTUATION MECHANISM and SINGLE
SEQUENTIAL ACTUATION MECHANISM.
● Always handle nails and package carefully. If nails
are dropped, collating wire may be broken.
● After nailing:
1) disconnect air hose from the Nailer;
2) remove all nails from the Nailer;
3) supply 5 – 10 drops of Hitachi pneumatic tool
lubricant into the air plug on the Nailer; and
4) open the petcock on the air compressor tank to
drain any moisture.

CHANGING THE EXHAUST DIRECTION

● When changing the exhaust direction, be
sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
The direction of the exhaust vent can be changed by
turning the top cover.
Exhaust Vent
WARNING
Top Cover