Troubleshooting Tips - Summit SPWD2200W User Manual

Care And Cleaning
Care and cleaning
Pull out the power plug to avoid electrical shock before washing.
After using the washing machine, pull out the power cord and close the door
tightly.
WARNING
Remove foreign matters
Drain Pump Filter:
Drain pump filter can filter threads and other foreign matter from the wash water.
Clean the filter periodically to ensure the normal operation of washing machine
According to the soil level within the cycles and the frequency of the cycles, you have
to inspect and clean the filter regularly.
The pump should be inspected if the machine does not empty and/or spin;
WARNING The machine makes an unusual noise during draining due to objects such as safety
pins, coins etc. blocking the pump.
To clean filter proceed as follows:
1.After the power is dis-
2.Turn the filter down as
connected, use hand to
shown with the figure and
take out foreign matter.
open the filter cover.
Warning!
When the appliance is in use and depending on the programme selected there can be hot water in the
pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished
the cycle, and is empty. When replacing the cover, ensure it is securely re-tightened.
.
3.Reinstall each part back
after foreign matter is removed.
P.25

Troubleshooting Tips

Troubleshooting tips
Troubles Reason
Washing machine
cannot start up
Door cannot be Machine's safety protection
opened design is working.
NTC is damaged and heating
Heating fault
pipe is aging.
The connection between inlet
pipe or outlet hose and tap or
Water leakage
washing machine is not tight.
Drain pipe in the room is blocked.
Water has
The inlet pipe is not connected
overflowed from
firmly.
the bottom of the
Outlet hose has water leakage.
machine
Power is disconnected.
Indicator or
PC board has problems.
display does
Harness has connection
not light.
problem.
Detergent
Washing powder is dampened
residues in the
and agglomerated.
box
Washing effects The clothes are too dirty.
are not good Insufficient detergent quantity.
Abnormal noise
Great vibration
Solution
Check if the door is closed tightly.
Check if power plug is inserted well.
Check if water supply tap is opened.
Check if button "On/Off" is pressed.
Check if button "Start/Pause" is pressed.
Disconnect the power.
Can normally wash the clothes.
Only cannot wash with heating.
Shall contact the service center promptly.
Check and fasten water pipes.
Clean up outlet hose and ask a
specialized person to repair it when
necessary.
Fix the inlet pipe.
Replace the drain hose.
Check if the power is shut down and
power plug is connected correctly.
If not, please call up service line.
Clean and wipe the box.
Use liquid detergents or the detergents
special for drum.
Select a proper procedure.
Add the proper detergent quantity
according to the instructions in
detergent package.
Check if the fixing bolts have been removed.
If cabinet is installed on a solid and level
floor.
Check if there are any barrettes or metal
articles inside.
Check if the legs on the washing machine
are adjusted level.
P.26