Coolant - Yamaha MAJESTY YP400A Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
1
2
3
1. Final transmission oil filler cap
2. O-ring
4
3. Final transmission oil drain bolt
4. Gasket
5
6. Install the final transmission oil
drain bolt and its new gasket, and
6
then tighten the bolt to the speci-
fied torque.
7
Tightening torque:
Final transmission oil drain bolt:
8
20 Nm (2.0 m·kgf, 14 ft·lbf)
7. Refill with the specified amount of
9
the recommended final transmis-
sion oil. WARNING! Make sure
that no foreign material enters
the final transmission case.
Make sure that no oil gets on the
tire or wheel.
[EWA11311]
Recommended final transmission
oil:
4
See page 9-1.
Oil quantity:
0.25 L (0.26 US qt, 0.22 Imp.qt)
3
8. Install the final transmission oil fill-
er cap and its new O-ring, and then
tighten the oil filler cap.
9. Check the final transmission case
for oil leakage. If oil is leaking,
check for the cause.
7-17

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
tion.
TIP
G
The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
G
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Pull up the right floorboard mat as
shown.
EAU20070
EAU34193