Step 1: Connect The Hotsync ® Cradle; Step 2: Charge Your Handheld - Palm i700 Getting Started

(If upgrading) Before you install new software, perform a
®
HotSync operation using your old handheld and cradle. This
ensures all data on your handheld is synchronized to your desktop
computer.
For successful operation of your Palm i700 series handheld, you
must install the version of Palm Desktop software that
accompanies the handheld. Look for the Palm Installation CD-
ROM.
If you encounter difficulties, reread the installation steps, paying
close attention to the notes and tips designed to help you through
the process.
For additional support information, go to: www.palm.com/
support/i705.
Step 1: Connect the HotSync

Step 2: Charge your handheld

Just place your handheld in the cradle for one hour for an initial
charge. Once your handheld is set up and in daily use, place it in the
cradle for a few minutes each day to recharge it to full capacity. Your
handheld's indicator light displays solid green when it is recharging.
To remove the handheld from the cradle, gently rock it forward
NOTE
and then lift it from the cradle.
Step 1: Connect the HotSync
®
cradle
Shut down and turn off your computer.
Plug the USB connector into a USB port on
your computer.
Connect the power cord that attaches to the
back of the cradle's USB port connector to
the AC adapter cord.
Plug the AC adapter into any AC current
outlet.
®
cradle
3