Electrolux EWF12932 User Manual page 17

5.2 Interruption Of A Program
- To pause press Start/ Pause.
The indicator will start flashing.
- Press the Start/Pause again.
The program will continue.
5.3 Changing A Program
Changing a running program is possible
only by switching off the appliance.
- Press the 'On/Off' button to cancel
the program and to turn off the
appliance.
- Press the 'On/Off' button again to start
the appliance. Now, you can set a new
washing program.
The appliance will not drain the
water.
5.4 Changing The Options
It is possible to change only some option
after the program has started.
1. Press the touchpad Start/Pause. The
indicator will start flashing.
2. Change the options.
3. Press Start/Pause again. The program
will continue.
5.5 Opening The Door
While a program or the Delay Start is
operating, the appliance door is locked
and the display shows the indicator '
First set the machine to PAUSE by pressing
the "Start/Pause" touchpad. Wait until the
door lock indicator '
door can be opened.
If the door lock indicator '
disappear, this means that the machine is
already heating and the water level is above
the bottom edge of the door or the drum is
turning. In this case the door CAN NOT be
opened.
'.
' goes off, then the
' does not
If you can not open the door but you
need to open it you have to switch
the machine off by pressing the
'On/Off' button to deactivate the
appliance. After about 5 minutes the
door can be opened.
CAUTION!
Pay attention to the water
level and water temperature.
5.6 At The End Of The Program
-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show '
-
The indicator of the touchpad
Start/Pause goes off.
-
The door lock indicator '
goes off.
-
Remove the laundry from the
appliance. Make sure that the
drum is empty.
- Keep the door ajar, to prevent the
mildew and odours.
-
Turn off the water tap.
At the end of the program the
time remaining can suddenly
decrease from 7 minutes or less
to 0 due to the overestimated
total program time during the
load sensing phase. In some
cases (with perfectly balanced
load) the program time can be
shorter than the time estimated
after the load sensing phase is
completed. This is a normal
behavior of the machine and
not a cause for concern as it
does not compromise its
performance.
ENGLISH 17
'.
'