Service Indicator; Thermostat Reset; Removing/Installing Thermostat; Default Thermostat Settings - Lennox L3711C Operation Manual

Comfortsense 3000 series 7-day programmable thermostat
Table of Contents

Advertisement

The default setting for the reminders is OFF (disabled).
Press Up/Down arrow buttons to select the desired re-
minder intervals.
Table 1. Filter and Maintenance Reminders
Buttons to
Reminder
Use
SETTINGS
FILTER
(1st press)
(1st press)
then Arrows
to scroll
to scroll
selections
SETTINGS
MAINTE-
(2nd press)
NANCE
then Arrows
then Arrows
to scroll
to scroll
selections
Enter
NOTE − The HOME screen will reappear about 15 seconds
after the final arrow button press. OR, press the ENTER
button at any time to store any changes and exit to the
HOME screen.
After either programmed interval has elapsed, the remind-
er will be displayed as shown in figure 16.
MO
I0:26
PROG
AM
A B C D
PM
HOLD
FAN
ON
AUTO
FILTER SERVICE
MAINTENANCE
ROOM
76
°
FAN
ON
AUTO
FILTER SERVICE
MAINTENANCE
ROOM
76
°
Figure 16. Reminders
After the filter has been changed or maintenance per-
formed, reset the reminder by pressing the SETTINGS
button for 4 seconds at the corresponding reminder set-
tings screen. The screen will blink for a few moments to in-
dicate that the timer has been reset.

Service Indicator

When abnormal equipment operation is detected, the
SERVICE indicator will flash on the screen (see figure 16).
This indicates that the equipment requires service from a
qualified service technician.
506072−01 02/08
Available Settings and
How to Use
Total fan run time expressed in
months (Off, 1, 3, 6, 12); for
months (Off 1 3 6 12); for
example, if fan runs 12 hours a
day, 1 month reminder displays
day 1 month reminder displays
in 2 calendar months.
Elapsed chronological time in
months (Off, 6, 12). Use this,
for example, to remind yourself
for example to remind yourself
when to perform routine checks
when to perform routine checks
or when to call a technician for
perodic preventive
perodic preventive
maintenance.
Stores settings.
Filter &
COOL
Maintenance
OFF
Indicators
AUTO
EMG.
HEAT
Service
COOL
OFF
Indicator
AUTO
Flashing
EMG.
HEAT

Thermostat RESET

Under some abnormal conditions, it may be necessary to
reset" the thermostat to its default condition. Such a RE-
SET would delete all programming and settings and there-
fore should only be used on rare occasions when the the
thermostat fails to function as designed and/or as pro-
grammed. Such an instance can occur as a result of a pow-
er surge or similar electrical disturbance (e.g. after an elec-
trical storm or power outage). The RESET button can be
used to recover from this situation.
When the RESET button is pressed, ALL settings re-
vert back to the defaults, including the default pro-
gram (see tables 2 and 3).
The RESET button is an unlabeled, recessed button lo-
cated behind the door on the right−hand side of the thermo-
stat, below the SETTINGS button (see figure 3). Use a pa-
per clip or small pencil to press the RESET button; ALL
thermostat settings will be reset to the defaults listed in the
Default Thermostat Settings section.

Removing/Installing Thermostat

The thermostat hinges on tabs on the top of the subbase;
no tool is needed to remove the thermostat from the sub-
base. Pivot the bottom of the thermostat outward (releas-
ing the snaps), then lift up to remove.
To replace it, first position the top tilted toward the wall
bracket and align it until you feel the tabs and slots engage;
then, while the top is in place, pivot the bottom toward the
wall until the thermostat snaps into place.

Default Thermostat Settings

Default thermostat settings are in table 2 and the default
program is shown in table 3.
Table 2. Default Thermostat Settings
Mode
Heat Setpoint (Perm Hold)
Cool Setpoint (Perm Hold)
Fan
Filter Reminder
Maintenance Reminder
Equipment Protection Timers
Autochangeover
Table 3. Default Program Settings −
Time & Temperature
Programs
Time
All days − A
6:00am
All days − B
8:00am
All days − C
6:00pm
All days − D
10:00pm 62_F / 17°C
Page 6
CAUTION
Heat (Perm. Hold)
70°F (or 21°C)
78°F (or 26°C)
Auto
OFF
OFF
Reset Back to Zero
OFF
Temp. − Heat Temp. Cool
70_F / 21°C
78_F / 26°C
62_F / 17°C
85_F / 29°C
70_F / 21°C
78_F / 26°C
82_F / 28°C

Advertisement

Table of Contents
loading

Table of Contents