Saving A Phrase Memory; Saving A Phrase Memory (Write); Deleting A Phrase Memory (Delete) - Boss RC-202 Owner's Manual

Saving a Phrase Memory

Saving a Phrase Memory (Write)

If you select a different phrase memory or turn off
the power after recording or editing the settings, the
recorded content or edited settings will be lost. If you
want to keep the data, you must save it.
MEMO
5 When you save a phrase memory, the bank
settings are also saved automatically.
5 You can also save during playback.
1.
Press the [WRITE] button.
2.
Use the [P. SHIFT] (1)–[DELAY] (8) buttons to
select the save-destination phrase memory.
5 This procedure is not required if the phrase memory
number is acceptable as is.
5 You can't overwrite-save to a phrase memory number
in which data is already saved (a phrase memory
whose button is lit).
5 You can switch the save-destination bank by turning
the [VALUE] knob.
5 If there's not enough memory to save a phrase
memory, the display indicates "E04". If this occurs,
delete an unwanted phrase memory and record once
again.
3.
Press the [WRITE] button to save the phrase
memory.
If you decide to cancel without saving, press the [SETUP]
(EXIT) button.
NOTE
* Please be aware that the contents of memory can be irretrievably lost as a result of a malfunction or improper
operation of the unit. You should back up important data as described in "Backing up to your computer" (p. 15).
* All due care is taken during repairs to avoid the loss of data. However, in certain cases, such as when there is
damage to the memory, it may not be possible to restore the data.
* Unfortunately, it may be impossible to restore the contents of data that was stored in the unit's memory once it has
been lost. Roland Corporation assumes no liability concerning such loss of data.
10

Deleting a Phrase Memory (Delete)

Here's how to delete the selected phrase memory.
* The RC-202 contains demo data (bank 8). If you
delete this data, it cannot be recovered. Before
you proceed, back it up as described in "Backing
up to your computer" (p. 15).
1.
Hold down the [WRITE] button for at least two
seconds.
2.
Use the [P. SHIFT] (1)–[DELAY] (8) buttons to
select the phrase memory that you want to
delete.
3.
Press the [WRITE] button to delete the phrase
memory.
If you decide to cancel without deleting, press the
[SETUP] (EXIT) button.