Stand Partslist - Roland HP-555G Service Notes

HP-555G
STAND PARTS LIST
Parts No. Description
# 01451867 REAR BOARD
71018889 SIDE BOARD R ASSY
NOTE : SIDE BOARD R ASSY includes the following parts.
******** SIDE BOARD R
# 01451901 TOE BLOCK
# 01451945 REAR HOLDER R
# 01451889 SIDE HOLDER R
01451912 LEG
22125675 ANGLE
00900045 JOINT HOLDER
22205518 JOINT HOLDER R
4 × 20mm TRUSS HEAD TAPPING A1 Fe BZC
40010678
4 × 35mm TRUSS HEAD TAPPING A1 Fe BZC
40010701
4 × 35mm FLAT HEAD TAPPING A1 Fe BZC
40019601
71018878 SIDE BOARD L ASSY
NOTE : SIDE BOARD L ASSY includes the following parts.
******** SIDE BOARD L
01451901 TOE BLOCK
# 01451934 REAR HOLDER L
# 01451878 SIDE HOLDER L
# 01451912 LEG
22125675 ANGLE
00900045 JOINT HOLDER
22205517 JOINT HOLDER L
4 × 20mm TRUSS HEAD TAPPING A1 Fe BZC
40010678
4 × 35mm TRUSS HEAD TAPPING A1 Fe BZC
40010701
4 × 35mm FLAT HEAD TAPPING A1 Fe BZC
40019601
# 71120045 PEDAL BOARD ASSY
NOTE : PEDAL BOARD ASSY includes the following parts.
22245308 PEDAL BOARD FELT
40011701 WOOD ANCHOR NUT M4*9.5 ZC
71019823 PEDAL UNIT
NOTE : PEDAL UNIT includes the following parts.
71018601 CONNECT CODE
NOTE : CONNECT CORD includes the following parts.
15229728 PHOTO INTERUPTER GP2S24B
15119112 TRANSISTOR 2SA1015-Y
13299199 TRIMMER EVND8AA03B13
00907045 PEDAL CABLE
71018623 PEDAL CENTER ASSY
N
OTE : PEDAL CENTER ASSY includes the following
parts.
******** PEDAL CENTER
01451667 FELT
22285396 ADJUST BOLT
00907045 PEDAL CABLE
00904190 PEDAL CHASSIS
00908023 FELT L
00904223 COILED SPRING
00908034 6*35mm JOINT BOLT
00677978 6*12mm JOINT NUT
40011278 3*8mm BINDING HEAD P-TITE FeBC
40011334 3*12mm BINDING HEAD P-TIGHT Fe BZC
# 71019923 KS-505/KS-505D SCREW SET
NOTE : SCREW SET includes the following parts.
5 × 20mm TRASS HEAD FeBZC ×2
40010589
4 × 25mm TRUSS HEAD TAPPING
40010689
A1 Fe BZC ×4
4 × 20mm PAN WASHER HEAD
# 40239278
TAPTITE C BZC × 8
4 × 16mm TRUSS HEAD TAPPING A1 Fe ZC
40010634
4 × 25mm TRUSS HEAD TAPPING A1 Fe ZC
40012123
3 × 10mm BINDING HEAD P TITE Fe BZC
40011323
4 × 25mm DOUBLE SEMS Fe ZC
40012923
3.1 × 10mm ROUND WOOD ZC
40011556
40016512 INSULOCK TIE 80M/M T-18S
40016578 VINYL TIE 150M/M
40016545 SKM-1 TIE HOLDER
40239023 LEAFLET
# 01451856 PACKING CASE
00898189 HEAD PHONE RH-30
01567034 STOOL(MAHOGANY)
REPLACING FDD MF355F-3252MG (PNo.01341956)
When replacing MF355F-3252MG, attach 4 adhesive acetate fiber
tape (PNo.40122612) (10mm wide) to the new FDD before
mounting it on HP-555G (see the figure below).
Important : The tape is to isolate vibration and must be
attached.
NOTE1 : Wrap the tape once around the FDD, covering at least
1mm from the bezel's edge as shown in the figure.
Make sure that the tape cannot be seen from the front
when HP-555G is assembled.
About 1—2mm
Bezel (Front Panel)
20
Nov. 1998
NOTE2 : Attach the tape along the bottom
surface as shown in the figure.
Attach it to the other side as well.
Top
Adhesive acetate fiber tape
Bottom
Screw Hole
NOTE3 : Wrap the tape once around and between
the screw holes on the bottom surface of
the FDD as shown in the figure.