Wheel And Deck Zerks; Transmission; Engine Oil - Husqvarna Z 246i Operator's Manual

LUBRICATION

Wheel and Deck Zerks

Use only good quality bearing grease.
Grease from well-known brand names
(petrochemical companies, etc.) usually maintains
a good quality.
Front Wheel Mount
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Deck Spindles
Lower the cutting deck completely. Lubricate with
a grease gun, 2-3 strokes per spindle through the
openings in the belt shields.

Transmission

The transmission is maintenance free. It is not
necessary to do level checks or oil changes. If
a leak occurs, replace the unit or contact your
Husqvarna dealer.

Engine oil

NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner's manual
for the correct replacement oil and filter change
recommendations.
WARNING! The engine drain plug is
located close to the muffler. To prevent burns,
the engine should be shut off and allowed to
cool slightly so the engine is still warm but the
surrounding surfaces and oil are not.
1. Park on a level surface. Apply parking brake.
2. Clean the dirt and debris from the area
around the oil fill cap.
3. Remove the cap/dipstick.
4. Locate the drain hose at the right rear of
the engine below the muffler. Place an
adequately sized container under the end of
the drain hose and remove the oil drain plug.
5. Allow the oil to fully drain from the engine.
6. Replace the drain hose plug and tighten
securely.
7. Fill the engine with new oil to the bottom of
the fill tube threads. Check the level with the
dipstick.
8. Replace the oil fill cap securely when the oil
level is FULL.
9. Refer to the Service Journal for oil checking
and changing intervals.
31