GE 162D9616P001 Use And Care Manual page 18

INSTALLING AND REMOVING PREVIOUSLY
In order to remove the decorator panels and replace with new panels
you need to remove the handles. A T-20 Torx driver is needed.
Removing the Handles:
1. Loosen and remove the 2 screws in the Top Trim.
2. Loosen and remove the 2 screws in the bracket that attaches the
Handle to the top of the Door.
3. Grip the Handle firmly and slide upwards. The keyhole slots on the
Handle slide off the buttons on the door.
4. Open the door and slide out the decorator panels.
Inserting the Door Panels:
Before installing the decorator panels, make sure they have been
routed out in the proper areas as shown in the beginning of this
section. Slide in the panels to perform a trial fit before fastening down
the Handle and Top Trim.
Installing the Handles:
Once the panels are fitted properly, install the Handle and Top Trim.
1. Slide the keyhole slots on the Handle down onto the buttons
mounted to the face of the door. Slide the Handle downward until
the bracket at the top of the Handle fits flush on the top of the door.
2. Replace the two screws in the bracket that attach the Handle to the
top of the Door and tighten the screws to 45 in-lbs torque.
3. Replace the Top Trim making sure it fits over the Side Trim and
that the locating tabs fit the inside of the Handle profile.
4. Replace the Top Trim screws and tighten to 30 in-lbs torque.
18
INSTALLED DECORATOR PANELS
Top Trim Screws
Buttons
Button
Bracket Screws
Bracket
Slots
Slot