Cleaning And Maintenance; Technical Information - Smeg KSEG 55X Instruction Manual

1.-
F
C
Speed Vitesse Velocidad Velocità Snelheid Absaugleistung Скорость Velocidade Hastighet
First Première Primera Prima Eerste
Second Deuxième Segunda Seconda Tweede
Third Troisième Tercera Terza
Afweren
Stop Arrêt Parada Arresto
Light Lumière Luz Luce
On Allumé Encendido Accesa
Off Eteint Apagado Spenta
2.-
G
D
A
B
Erste Первая Primeira
Zweite Вторая Segunda
Derde
Dritte Третья Terceira
Halt Стоп Parar
Licht
Beleuchtung Свет Luz
Aan Ein Включен Acesa
Uit Aus Выключен Desligada
H
Instructions for use
By pushing buttons shown in the figure 1, you
will be able to control the functions of the
extractor
Two achieve better extraction, we recommend
switching on the extractor a few minutes
before starting to cook (3 - 5 minutes) so that
the air flow is continuous and stable when
E extracting the fumes.
Likewise, keep the extractor switched on for a
few minutes when cooking is complete to
allow all fumes and odours to be expelled.

Cleaning and maintenance

Before carrying
maintenance
extractor is disconnected from the mains.
To carry out cleaning and maintenance, follow
the Safety Instructions.
There is a fire risk if cleaning is not carried out
in accordance with the instructions.
Första Filter cleaning
To remove the filters from their locations
Andra
release the anchoring points. Clean the filter,
Tredje
either by putting it in the dishwasher (see
Parade
notes) or leaving it standing in hot water to
simplify the removal of grease or, if wished, by
Lampa
means of special sprays (protecting the non
På
metallic parts). Once clean, leave it to dry.
Av
Notes: cleaning in the dishwasher with
aggressive detergents may darken the surface
of metallic parts, without this affecting its gas
retaining properties.
N.B. The filter must be cleaned at least once a
month depending on how often the extractor is
used. It must be remembered that grease
accumulates in the extractor when cooking,
whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor, paying
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
* Never use metallic scouring pads or abrasive
products that could damage the surface.
* Do not use scrapers with metallic surfaces
such as knives, scissors etc.
Active charcoal filter
* To install the charcoal filter press the anchor
points onto each side of the motor and turn
clockwise.
* The carbon filters last from three to six
months
conditions of use.
* The activated carbon filters can neither be
washed nor regenerated. Once they are
exhausted, they must be changed.
* To replace used filters with new ones,
withdraw the old ones in the reverse order to
that of installation
out any cleaning or
activities, ensure that the
Changing Bulbs
* It
disconnected, and ensure the bulbs that are
to be replaced are not hot.
* Remove the light lens to expose the
extractable lamps.
* The maximum bulbs power is 20W.
Dimensions
Dimensions for fitting
Electrical characteristics:
REFER TO RATING PLATE
depending on the particular
.
is important that the mains are

Technical Information

(Fig.3)
Width = 550 mm
Depth = 310 mm
Height = 190 mm
Width = 505 mm
Depth = 292 mm