Connecting The Cisco Rv134W - Cisco RV134W Quick Start Manual

Connecting the Cisco RV134W

3
You must connect one PC with an Ethernet cable for the purpose of
N
OTE
the initial configuration. After you complete the initial configuration,
administrative tasks can be performed using a wireless connection.
To connect a PC to the Cisco RV134W for initial configuration:
Power off all equipment, including the cable or DSL modem, the
S 1
TEP
PC, and the Cisco RV134W .
For Ethernet WAN connections, connect one end of the Ethernet
S 2
TEP
cable to your Internet access device (typically a modem), and
connect the other end of the cable to the WAN port.
For VDSL connections, connect your DSL cable directly to the
VDSL port on the device. If required by your Service Provider,
make sure that you use a DSL splitter.
For 3G/4G WAN connection, connect the 3G/4G USB dongle into
the USB port. Then, the firewall router will detect the 3G/4G dongle
and subscribe to the ISP network.
Note: This application must use the specific 3G/4G dongle which is
supported by the router. The 3G/4G SIM card must be configured
with the user defined PIN code.
Connect another Ethernet cable from one of the LAN (Ethernet)
S 3
TEP
ports to the Ethernet port on the PC.
Power on the cable or DSL modem and wait until the connection is
S 4
TEP
active.
Connect the power adapter to the device's POWER port.
S 5
TEP
Use only the power adapter that is supplied with the unit.
C
AUTION
Using a different power adapter could damage the device.
The POWER button is on by default. The power light on the front
panel is solid green when the power adapter is connected
properly and the device is finished booting.
Plug the other end of the adapter into an electrical outlet. Use the
S 6
TEP
plug (supplied) specific to your country.
Continue with the instructions in the
S 7
TEP
configure the device.
6 Cisco RV134W VDSL2 Wireless-AC Quick Start Guide
Using the Setup Wizard to