Yamaha WR250F 2016 Owner's Service Manual page 211

TIP
Apply the lithium-soap-based grease to the
contact surface of the steering stem nut when
installing.
9. After tightening the nut, check the steering
for smooth movement. If not, adjust the
steering by loosening the steering ring nut
little by little.
10.Adjust:
• Front fork top end "a"
Front fork top end (standard) "a"
5 mm (0.20 in)
a
11.Tighten:
• Pinch bolt (upper bracket) "1"
Upper bracket pinch bolts
21 Nm (2.1 m·kgf, 15 ft·lbf)
• Pinch bolt (lower bracket) "2"
Lower bracket pinch bolts
21 Nm (2.1 m·kgf, 15 ft·lbf)
EWA
WARNING
Tighten the lower bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
2
12.Install:
• Speed sensor lead holder "1"
• Speed sensor lead clamp "2"
Speed sensor lead holder bolt
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
Speed sensor lead clamp bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
• Insert the end of the speed sensor lead holder
in the hole in the lower bracket "a".
• Install so that the marking "b" on the speed
sensor lead aligns with the speed sensor lead
holder edge.
• Install the speed sensor lead clamp while in-
serting it in the hole "c" in the speed sensor
lead holder.
5-57
STEERING HEAD
1