Yamaha YZF-R6 Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
If the multi-function display indicates
any error codes, note the code number,
and then have a Yamaha dealer check
the vehicle.
CAUTION:
If the display indicates an error
code, the vehicle should be checked
3
as soon as possible in order to avoid
engine damage.
Display brightness and shift timing
indicator light control mode
1. Shift timing indicator light
2. "SELECT" button
3. "RESET" button
This mode cycles through five control
functions, allowing you to make the fol-
lowing settings in the order listed be-
low.
G Display brightness:
ECA11590
This function allows you to adjust
the brightness of the multi-function
display to suit the outside lighting
conditions.
G Shift timing indicator light activity:
This function allows you to choose
whether or not the indicator light
should be activated and whether it
should blink or stay on when acti-
vated.
G Shift timing indicator light activa-
tion:
This function allows you to select
the engine speed at which the indi-
cator light will be activated.
G
Shift timing indicator light deactiva-
tion:
This function allows you to select
the engine speed at which the indi-
cator light will be deactivated.
3-10
G
Shift timing indicator light bright-
ness:
This function allows you to adjust
the brightness of the indicator light
to suit your preference.
NOTE:
G
To make any settings in this mode,
you have to cycle through all of its
functions. However, if the key is
turned to "OFF" or the engine is
started before completing the pro-
cedure, only the settings made be-
fore the "SELECT" button was last
pushed will be applied.
G
In this mode, the multi-function dis-
play shows the current setting for
each function (except the shift tim-
ing indicator light activity function).
To adjust the display brightness
1. Turn the key to "OFF".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to "ON", and then, af-
ter five seconds, release the "SE-
LECT" button.