Advertisement
RE-CONE KIT
A re-cone kit is available for these speakers and can be obtained from your dealer. The
part number for each model is listed below.
Model
HCCA10.2CK ORION HCCA 10" 2 OHM Re-Cone Kit
HCCA10.4CK ORION HCCA 10" 4 OHM Re-Cone Kit
HCCA12.2CK ORION HCCA 12" 2 OHM Re-Cone Kit
HCCA12.4CK ORION HCCA 12" 4 OHM Re-Cone Kit
HCCA15.2CK ORION HCCA 15" 2 OHM Re-Cone Kit
HCCA15.4CK ORION HCCA 15" 4 OHM Re-Cone Kit
RE-CONE STEPS
Note: Step seven in the re-cone process must be altered when re-coning the 10"
Woofers. See section Alternate step 7—for 10" Woofers at the end of this manual.
Refer to the exploded view at the end of this manual while using the following
procedure.
Note: Before beginning, record the positions of terminals and logos so the new
re-cone assembly can be installed the same way.
1. Remove Spider Ring bolts (eight), from the bottom side of the basket. Bolts can
be removed with included Allen wrench. To get access the basket may need to
be turned on its side.
2. Place the speaker facing up and remove the Edge Clamping Ring. There are 8 Allen
head bolts on the 10 & 12" models and 12 on the 15" model that clamp the
surround edge to the basket. These are removed using the included Allen wrench.
3. The Moving Parts Assembly (cone/spider) can now be removed from the basket.
Note that the edge has a small amount of PVA adhesive attaching it to the basket.
Lifting one section of the edge will break this bond and facilitate lifting the edge
free. Be sure to remove any residual residue before installing the new assembly.
Alcohol and a Q tip or soft lint-free rag can be used to clean the surface.
4. Make note of any obvious problems, (voice coil burnt, mechanical marks on the
coil, etc.) Discard the old Moving Parts Assembly. Contact Technical Support for
advice regarding observed abnormal conditions. Be sure to remove all remnants
of the old voice coil assembly before trying to install the new re-cone kit. If there
is any residue present in the gap, it can be cleaned with alcohol and a Q tip.
Description
2
Re-cone Kit p/n
27902
27904
27907
27909
27912
27914
Advertisement
