Asus H170I-PRO User Manual page 16

Audio 2.1, 4.1, 5.1 or 7.1-channel configuration
Port
Light Blue
(Rear panel)
Lime (Rear panel)
Pink (Rear panel)
Lime (Front panel)
For a 7.1-channel speaker setup, refer to the 7.1-channel configuration in the table.
9. USB 3.0 ports. These 9-pin Universal Serial Bus (USB) ports connect to USB 3.0/2.0
devices.
•
•
•
•
10. HDMI port. This port is for a High-Definition Multimedia Interface (HDMI) connector,
and is HDCP compliant allowing playback of HD DVD, Blu-ray, and other protected
content.
11. DisplayPort port. This port is for a DisplayPort-compatible devices.
12. DVI-D port. This port is for any DVI-D compatible device. DVI-D can't be converted to
output RGB Signal to CRT and isn't compatible with DVI-I.
1-8
Headset
2.1-channel
Line In
Line Out
Mic In
—
Due to USB 3.0 controller limitations, USB 3.0 devices can only be used under a
Windows OS environment and after USB 3.0 driver installation.
®
The plugged USB 3.0 device may run on xHCI or EHCI mode, depending on the
operating system's setting.
USB 3.0 devices can only be used for data storage.
We strongly recommend that you connect USB 3.0 devices to USB 3.0 ports for faster
and better performance from your USB 3.0 devices.
4.1-channel 5.1-channel
Rear Speaker Out Rear Speaker Out Rear Speaker Out
Front Speaker Out Front Speaker Out Front Speaker Out
Mic In Bass/Center
—
7.1-channel
Bass/Center
— Side Speaker Out
Chapter 1: Product introduction