Replacing The License Plate Light Bulb; Replacing An Auxiliary Light; Bulb - Yamaha XCITY VP250 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
ZAUM0680
1. Tail/brake light bulb socket
2. Turn signal light bulb socket
5. Remove the burnt out bulb by
pushing it in and turning it counter-
clockwise.
6 6. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
7. Install the socket (together with the
bulb) by turning it clockwise.
8. Install the screws
tail/brake light unit.
9. Install the panel.
Replacing the license plate
light bulb
1. Remove the socket (together with
the bulb) by pulling it out.
2
1
ZAUM0681
1. License plate light bulb socket
2. Remove the burnt out bulb by pull-
ing it out.
3. Insert a new bulb into the socket.
4. Install the socket (together with the
bulb) by pushing it in.
and the
EAUM2201
1
6-27

Replacing an auxiliary light

bulb

This model is equipped with two auxil-
iary lights. If an auxiliary light bulb burns
out, replace it as follows.
1. Remove cowling A. (See page
6-6.)
2. Remove the socket (together with
the bulb) by pulling it out.
ZAUM0682
1. Auxiliary light bulb socket
3. Remove the burnt out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the cowling.
EAUM2212
1