Cleaning And Lubricating The Drive Chain - Yamaha FAZER FZ1-S Owner's Manual

Hide thumbs Also See for FAZER FZ1-S:
Table of Contents

Advertisement

PERIODIC MAINTENANCE AND ADJUSTMENT
Drive chain slack:
20.0–30.0 mm (0.79–1.18 in)
5. If the drive chain slack is incorrect,
adjust it as follows.
To adjust the drive chain slack
1. Loosen the axle nut and the lock-
nut on each side of the swingarm.
2. To tighten the drive chain, turn the
drive chain slack adjusting bolt on
each side of the swingarm in direc-
tion (a). To loosen the drive chain,
turn the adjusting bolt on each side
of the swingarm in direction (b),
6
and then push the rear wheel for-
ward. NOTICE: Improper drive
chain slack will overload the en-
gine as well as other vital parts
of the motorcycle and can lead
to chain slippage or breakage.
To prevent this from occurring,
keep the drive chain slack with-
in the specified limits.
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both drive chain pullers are in the same
position for proper wheel alignment.
EAU34315
5
1. Axle nut
2. Drive chain slack adjusting bolt
3. Locknut
4. Drive chain puller
5. Alignment marks
3. Tighten the axle nut, then the lock-
nuts to their specified torques.
Tightening torques:
[ECA10571]
Axle nut:
150 Nm (15.0 m·kgf, 110 ft·lbf)
Locknut:
16 Nm (1.6 m·kgf, 11 ft·lbf)
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
1
2 3
wet areas. Service the drive chain as
(a)
follows.
(b)
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
4
in the rain or riding in wet areas.
1. Clean the drive chain with kero-
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
6-24
sene and a small soft brush.
NOTICE: To prevent damaging
the O-rings, do not clean the
drive chain with steam cleaners,
high-pressure washers or inap-
propriate solvents.
[ECA11121]
chain with a special O-ring chain
lubricant. NOTICE: Do not use
engine oil or any other lubri-
cants for the drive chain, as they
EAU23025
ECA10583

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fazer fz1-sa

Table of Contents