Philips 190VW8FB/93 Service Manual page 61

3. LCD SPECIFICATION
3.1 LCD specification
Type NR.
Outside dimensions
Pitch ( mm )
Color pixel
arrangement
Display surface
Color depth
Backlight
Active area(WxH)
View angle
Contrast ratio
White luminance
Gate IC
Source IC
Response time
4 COSMETICS APPEARANCE
4.1 GAP definition
The gap between LCD and front bezel must be <= 1.0mm
4.2 Panel Offset
Panel Offset: Panel disposition tolerance inside the front bezel must be <=1.0mm
4.3 Horizontal tilt
Horizontal tilt between front bezel & LCD shall be <= 1.0mm
5. CONNECTORS
5.1 Video Connection
The monitor is equipped with a 15 pin mini D-SUB connector.
5.2 PIN Assignment
5.2.1 15 pin mini D-Sub connector
The PIN assignment of the 15 pin mini D-SUB connector / cable is as follows:
PIN No.
1 Red
2 Green/ SOG
3 Blue
LPL
LPL, LM190WX1-TLA1
427.2(H) x 277.4(V) x 15.3(D)
mm(Typ.)
0.095*RGB(H)mm x 0.285(V)mm
RGB vertical stripes
Hard coating (3H), Anti-glare treatment
of the front polarizer
16.7M colors
CCFL edge light system
410.4 (H) x 256.5 (V)
R/L 160(Typ.), U/D 160(Typ.)
1000:1(Typ.) 700:1(Min.)
Original color 250 nits (Min), 300 nits
(Typ.)
OKI MT3805VA
MAGNA D10D3SS639
5ms (typ)
SIGNAL
CMO
CMO, M190A1-L07
427.2(w)*277.4(h)*17.0(d) (Typ) mm
0.285 mm x 0.285 mm
RGB vertical stripes
low reflection, antiglare with hard
coating
16.7M colors ( 6 bits+FRC )
CCFL edge light system
410.4 x 256.5mm (19.05" diagonal)
75/75 (min), 85/85 (typ) for Horizontal &
70/70 (min), 80/80 (typ) for Vertical
850:1(Typ.) 500:1(Min.)
Original color 230 nits (Min), 300 nits
(Typ.)
Himax ( HX8636A )
Himax ( HX8018A )
5ms (typ)
190VW8 LCD
61