Table of Contents
Advertisement
10. Reinstall the belt covers onto the cutting unit, then
reinstall and tighten the knobs/rubber washers.
11. Reinstall the carrier frame cover onto the cutting unit,
then reinstall and tighten the knobs/rubber washers.
3
Figure 64
1. PTO clutch pulley
2. Drive belt idler
Replacing the Caster Wheel
Fork Bushings
The caster wheel forks are mounted in bushings pressed
into the top and bottom of the carrier frame mounting
tubes. To check the bushings, move the caster forks back
and forth and side-to-side. If a caster fork is loose, the
bushings are worn and must be replaced.
1. Raise the cutting unit so the caster wheels are off the
floor, then block up the front of the mower with jack
stands.
2. Remove the locking pin and spacer(s) from the top of
the caster wheel fork (Fig. 65).
3. Pull the caster wheel fork out of the mounting tube,
leaving the spacer(s) on the bottom of the fork.
Remember the location of the spacers on each fork to
ensure correct installation, and to maintain a level deck.
1
2
4
m–5247
3. Drive Belt
4. Double Spindle Pulley
41
1
3
4
Figure 65
1. Locking Pin
2. Spacers (locate as
required)
4. Insert a pin punch into the mounting tube and carefully
drive out the bushings (Fig. 66). Clean the inside of the
mounting tube.
5. Grease the inside and outside of the new bushings. Use
a hammer and flat plate to carefully drive the bushings
into the mounting tube.
6. Inspect the caster wheel fork for wear and replace if
necessary (Fig. 65).
7. Slide the caster wheel fork through the bushings in the
mounting tube. Replace the spacer(s) onto the fork and
secure with the retaining ring (Fig 65).
Important
The inside diameter of the bushings may
collapse slightly when installed. If the caster wheel fork
does not slide into the new bushings, ream both bushings to
an inside diameter of 1.126 inch (29 mm).
8. Grease the fitting on the carrier frame mounting tube
using No. 2 general purpose lithium base or
molybdenum base grease.
2
1
2
Figure 66
1. Mounting Tube
2
2
m–6372
3. Carrier frame mounting
tube
4. Caster wheel fork
m–6373
2. Bushing
Advertisement
Table of Contents
