Table of Contents
Advertisement
2. Check the traction pedal stop adjustment. The distance
from the top of the stand to the top of the stop must be
1-1/2 in. (38 mm) (Fig. 67). Loosen the nuts and adjust,
as required.
1
Figure 67
1. Traction pedal stop
3. Loosen the jam nuts on the rod end and adjust the
traction rod length (Fig. 68) so that the pedal contacts
the pedal stop when the pump lever reaches full stroke.
Secure the jam nuts.
4
2
1
Figure 68
1. Rod end
2. Traction rod
4. Turn the key switch to the run position without starting
the engine. Loosen the jam nut and adjust the neutral
return spring assembly shaft length until the audible
alarm begins to sound. Secure the jam nut.
5. Turn the key switch off.
1-1/2 in.
(38 mm)
2
2. Stand
3
3. Neutral return spring
assembly
4. Jam nut
45
Adjusting the Service Brakes
Adjust the service brakes when there is more than 1 in.
(25 mm) of "free travel" of the brake pedal, or when the
brakes do not work effectively. Free travel is the distance
the brake pedal moves before braking resistance is felt.
1. Disengage the locking latch from the brake pedals so
that both pedals work independently of each other.
2. To reduce free travel of the brake pedals, tighten the
brakes:
A. Loosen the front nut on the threaded end of the
brake cable.
B. Tighten the rear nut to move the cable backward
until the brake pedals have 1/2 to 1 in. (13 to
25 mm) of free travel.
C. Tighten the front nuts after the brakes are adjusted
correctly.
Changing the Planetary Gear
Drive Oil
Change the oil initially after first 200 hours of operation.
Thereafter change the oil every 800 hours, or yearly,
whichever occurs first. Use a high quality SAE 85W-140
wt. gear lube.
1. With the machine on a level surface, position the wheel
so that the check/drain plug (Fig. 69) is at the lowest
position.
Figure 69
1. Check/drain plug
1
Advertisement
Table of Contents
