Recovery Volume Options; Degraded Raid Array; Missing Hard Drive Member - MSI Z170M MORTAR Assembly Instruction Manual

Important
● You will lose all data on the RAID drives and any internal RAID structures when you
perform this operation.
Possible reasons to Reset Disks to Non-RAID could include issues such as
●
incompatible RAID configurations or a failed volume or failed disk.

Recovery Volume Options

Select option Recovery Volume Options from the main menu screen and press
Enter to change recovery volume mode. The following screen appears:
Recovery mode will change from Continuous Update to On-Request after you enable
Only Recovery Disk or Only Master Disk.

Degraded RAID Array

A RAID 1, RAID 5 or RAID 10 volume is reported as degraded when one of its hard
drive members fails or is temporarily disconnected, and data mirroring is lost. As a
result, the system can only utilize the remaining functional hard drive member. To
re-establish data mirroring and restore data redundancy, refer to the procedure below
that corresponds to the current situation.
RAID Volumes
ID Name
0 Volume0
Physical Disks:
Port Device Model
1 XXXXXXXXXXXXX
2 XXXXXXXXXXXXX
Press <CTRL-I> to enter Configuration Utility..

Missing Hard Drive Member

1. Power off.
2. Reconnect the hard drive.
[ RECOVERY VOLUME OPTIONS
1.
2.
Enable Only Recovery Disk - enables recovery disk if available and
Enable Only Master Disk - enables master disk if available and
disables recovery disk.
Actions will result in change from Continuous Update mode to On-Request.
[ ↑↓] - select [ESC] - Previous Menu
Level
RAID 1(Mirror)
Serial #
XXXXXXXXXXXXX
XXXXXXXXXXXXX
Enable Only Recovery Disk
Enable Only Master Disk
[ HELP ]
disables master disk.
Strip Size Status
N/A XXX.XGB Degraded
Size
XXX.XGB
XXX.XGB
]
[ENTER] - Select
Bootable
Yes
Type/Status(Vol ID)
Member Disk (0)
Member Disk (0)