Only For Training And Service Purposes - LG 32LM5800 Service Manual

4.7. EYE-Q function check
Step 1) Turn on TV
Step 2) Press EYE key of Adj. R/C
Step 3) Cover the Eye Q II sensor on the front of the using
your hand and wait for 6 seconds
Step 4) Confirm that R/G/B value is lower than 10 of the "Raw
Data (Sensor data, Back light )". If after 6 seconds,
R/G/B value is not lower than 10, replace Eye Q II
sensor
Step 5) Remove your hand from the Eye Q II sensor and wait
for 6 seconds
Step 6) Confirm that "ok" pop up.
If change is not seen, replace Eye Q II sensor
4.8. Local Dimming Function Check
Step 1) Turn on TV
Step 2) At the Local Dimming mode, module Edge Backlight
moving right to left
Back light of IOP module moving
Step 3) confirm the Local Dimming mode
Step 4) Press "exit" Key
Copyright © LG Electronics. Inc. All rights reserved.

Only for training and service purposes

4.9. 3D function test
( Pattern Generator MSHG-600, MSPG-6100 [SUPPORT
HDMI1.4])
* HDMI mode NO. 872 , pattern No.83
1) Please input 3D test pattern like below (HDMI mode NO.
872 , pattern No.83)
2) When 3D OSD appear automatically , then select OK button
3) Don't wear a 3D Glasses, Check the picture like below .
- 18 -
LGE Internal Use Only