Before Operating This Recorder - Toshiba D-R4SU Owner's Manual

Introduction

Before operating this recorder

Is your recorder ready?
• Refer to "INSTALLATION GUIDE" and finish the
necessary preparations.
• Turn on the connected equipment such as a TV or
audio system and select the input from the recorder.
Turning the power on
(This owner's manual instructions are based on
the premise that all proper connections have been
completed and the TV is turned on.)
Press ON/STANDBY on the front panel of the
recorder or on the remote control.
ON/STANDBY button
When the power turns on, the LED on the front panel
illuminates.
After a few seconds, a start-up screen appears.
The following icon appears at the top right corner of
the screen.
e.g.
When this icon disappears, the recorder is ready to
operate. If the disc drive contains a disc, it takes a
little longer to start up.
Viewing TV channels through this recorder
After turning the power on, the recorder will output TV
channel signals to the connected TV (also in the stop
mode).
You can select a desired channel by pressing the CH
button, or the number buttons.
Downloaded From Disc-Player.com Toshiba Manuals
20
LED
ON/STANDBY button
CH button
Loading
Loading a disc
Check disc compatibility beforehand (
and use a proper playable disc.
Caution
• Keep your fingers well clear of the disc tray. Neglecting this
may cause serious personal injury. Keep a close watch on
children.
• Do not use a cracked, deformed, or repaired disc.
1 Open the disc tray.
Press on the front panel or OPEN/CLOSE on
the remote control.
button
OPEN/CLOSE button
2 Insert a disc.
Disc without a cartridge
Insert with the playback side down.
There are two kinds of disc size. Place a disc to fit
the guide. If a disc is out of the guide, it may result
in damage to the disc or malfunction.
page 6, 7)
Place a disc in the
inside hollow.