Page 1
S I M P L Y A M A Z I N G ™ ’ UIDE XLS465 XLS465A •IMPORTANT• SAVE THIS BOOKLET! Includes: • Warranty • Safety Warnings • Parts List • Operating Instructions • Accessories List • Trouble Diagnosis...
Authorized ORECK Service Center. ORECK will provide all parts and labor without charge, during the warranty period, to place this appliance in correct operating condition. or call customer service at •...
If you purchase this product from any other source, your purchase is “AS IS,” which means ORECK grants you no warranty, and that you, not ORECK, assume the entire risk of the quality and performance of this product, including the entire cost of any necessary servicing or repairs of any defects.
Figure 1 Slide Handle forward Figure 3 Figure 4 THE ONLY TOOL YOU WILL NEED IS A PHILLIPS- TYPE SCREWDRIVER! ASSEMBLY STEP ONE (Figure1): Attach Handle to Cleaner 1. Lay the cleaner on a flat surface with the tank side down or to its side.
POLARIZATION INSTRUCTIONS To reduce the risk of electric shock, the ORECK STEEMER model is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into a polarized outlet only one way.
Professional Carpet Cleaner on a clean white cloth and blot carpet. Examine this cloth for color removal; if color appears on the cloth, the carpeting is not colorfast and should not be cleaned with the ORECK STEEMER wet extraction process. This product is not recommended for use on carpets made from silk, velvet, wool and some cotton blends.
Page 8
To shorten the drying time, go back over the carpet pulling slowly backwards without depressing the gray button (Figure 14). Repeat this procedure until you do not see water being pulled from the carpet through the nozzle. CAUTION: Do not allow the lower recovery tank to overfill.
Page 9
In such cases, the ORECK STEEMER can be a fast and easy tool to assist in most types of spill pick-ups. Several key precautions must be followed to insure operator safety: 1.
Clean Carpet Cleaner WARNING: To reduce the risk of electric shock or injury from moving parts, unplug before servicing. 1. Before turning the cleaner off, tilt the cleaner back, raising the nozzle off the carpet for 15-20 seconds. This prevents extracted water in the nozzle from dripping back onto the carpet after you turn the cleaner off.
10. Replace belt cover, brush roll clamp and screws. 11. Reconnect power cords and test. Call your authorized ORECK Home Care Center, your authorized ORECK dealer, or call the Home Care Hotline toll free at 1-888-742-6769. ccessories STEEMER Full Release™...