Table of Contents
Advertisement
Appendices
46
English
Intermission Problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and
wait at least 60 seconds before reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replace the
lamp, follow the procedures in the "Replacing the Lamp" section
on pages 48-49.
Projector Status Indication
LED lighting message
Message
Standby State
(Input power cord)
Power on (Warming)
Lamp lighting
Error (Over Temp.)
Error (Fan fail)
Error (Lamp fail)
Steady light
Power LED
(Green/Amber)
Flashing
Amber
Flashing
Green
Green
(0.25s on, 0.25s off)
No light
Temp-LED
Lamp-LED
(Red)
(Red)
Flashing
Advertisement
Table of Contents
