Electrical Connections - GE JP989 Owner's Manual & Installation Instructions

14 ATTACHING THE BLOWER
TRANSITION DUCT
Use the blower transition duct that is packed with your
cooktop for all downward duct installations to connect
to 6" round standard ductwork.
NOTE: Use Rear Wall Adapter Kit JXRW89 for duct
installations through the rear cabinet wall and retrofits
of older 5"-duct-size cooktops.
Screws
Remove the cardboard packing in the blower outlet.
Install the transition duct to the blower outlet with three
(3) sheet metal screws provided. Secure all joints with
duct tape to assure an airtight seal.
CONNECTING THE DUCTWORK
15
Connect the ductwork prepared in Steps 5 and 6 to the
blower transition duct.
Installation Instructions
INSTALLING THE COOKTOP
Screw
(on other side)
16 BLOWER ELECTRICAL
CONNECTIONS
• Loosen the screws and remove and discard the sheet
metal strap covering the 5-pin connector. Save the
screws for reinstallation later.
• Connect the 5-pin plug on the blower assembly to the
matching 5-pin receptacle on the bottom of the wire
enclosure.
• Fold all wires into the electrical enclosure. Secure
the enclosure with the screws removed earlier,
making sure that no wires are trapped.
24
5-pin connectors
5-pin
connectors
Electrical
enclosure
Flexible
conduit