Fcc & Ices Compliance - Bosch WZ20 Installation Manual

en | Safety
10
1.4 FCC & ICES compliance
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions.1. This device may
not cause harmful interference.2. This device must accept any
interference received, including interference that my cause
undesired operation.
FCC Information
(U.S.A. and Canadian Models Only)
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer, an experienced radio/TV technician, or
Bosch Security Systems for support.
Intentional or unintentional modifications, not expressly
approved by the party responsible for compliance, shall not be
made. Any such modifications could void the user's authority to
operate the equipment. If necessary, the user should consult
the dealer or an experienced radio/television technician for
corrective action. The user may find the following booklet,
prepared by the Federal Communications Commission, helpful:
| 1.0 | 2011.02 Installation Manual
Integrated IR Bullet Camera
Bosch Security Systems, Inc.