Installing The Cable-Management Brackets - Cisco uBR7246VXR Hardware Installation

Figure 7 Installing the Rack-Mount Brackets in the Middle of the Chassis for Open or Relay-Type Racks
Rack-mount bracket

Installing the Cable-Management Brackets

If you are rack-mounting the chassis at the rear or middle of the chassis, both rack-mount brackets and the cable-management
bracket must be installed before the chassis is installed in the rack. See Figure 8 for cable management bracket locations.
To install the cable-management bracket, complete the following steps:
Step 1 Align the cable-management bracket with the four right front threaded holes in the chassis.
Step 2 Thread four M4 x 6-mm Phillips flathead screws through the bracket and into the chassis, and use a number 2 Phillips
screwdriver to tighten the screws.
Figure 8 Location of Cable Management Bracket
1
Cable-management
Rack-mount
bracket
1 Location of cable management bracket—rear mount
2
bracket
Rack-mount
bracket
Cable
management
bracket
Rack-mount
bracket
2 Location of cable management bracket—middle mount
11