Mechanical Instructions - Philips TDVD1.1E Service Manual

www.freeservicemanuals.info
EN 14 4. TDVD1.1E

4. Mechanical instructions

Index of this chapter:
1. Rear Cover Removal
2. Service Position Main Panel
3. DVD Module Removal
4. Side I/O Panel Removal
5. Rear I/O Panel Removal
6. Rear Cover Mounting
Note:
Figures can deviate slightly from the actual situation.
4.1 Rear Cover Removal
1. Remove all fixation screws (7x) of the rear cover.
2. Pull the rear cover a little backwards.
3. Disconnect the Rear I/O and Side I/O panel cables
4. Now pull the rear cover backwards to remove it.
4.2 Service Position Main Panel
1. Disconnect all cables of the DVD module.
2. Remove the main panel, by pushing the two centre clips
outward [1]. At the same time, pull the panel away from the
CRT [2].
3. Turn the panel 90 degrees clockwise [3].
4. Flip the panel 90 degrees [4], with the components towards
the CRT.
A
3
2
B
4
Figure 4-1 Service position Main panel
Mechanical instructions
1
1
CL 26532120_027.eps
311002
4.3 DVD Module Removal
Remove the complete DVD module after unscrewing the four
fixation screws [1].
Figure 4-2 Disassemble DVD module
4.4 Side I/O Panel Removal
Remove the side I/O panel after unscrewing the screw from the
outside of the rear cover.
4.5 Rear I/O Panel Removal
Remove the rear I/O panel after unscrewing the two screws
from the inside of the rear cover.
4.6 Rear Cover Mounting
To reassemble the set, perform all described processes in
reverse order.
Be sure that, before the rear cover is mounted:
• The mains cord is mounted correctly in its guiding bracket.
• All wires/cables are returned in their original position.
CL 26532120_026.eps
311002