Table of Contents
Advertisement
Operating Instructions
Starting/Stopping The Engine
IMPORTANT: The fuel system may have to be
bled if any of the following situations have
occurred:
•
Initial start up of a new engine.
•
The engine has ceased running due to lack of
fuel.
•
Maintenance has been done on fuel system
components; i.e., the filter replaced, etc.
Refer to Bleeding The fuel System
1.
Be sure the parking brake is set and the reel drive
switch is in DISENGAGE.
2.
Remove your foot from the traction pedal and
make sure the pedal is in the neutral position.
3.
Move the throttle lever to the full throttle posi-
tion.
4.
Remove the cover from the ignition switch.
Insert the key and turn it counterclockwise to the
GLOW PLUG position—and hold it there for
approximately 20 to 30 seconds. Then, turn the
key clockwise to START to engage the starter
motor. Release the key when the engine starts.
The key will move automatically to ON.
IMPORTANT To prevent overheating the
starter motor, do not engage the starter longer
than 10 seconds. After 10 seconds of continu-
ous cranking, wait 60 seconds before engaging
the starter motor again.
5. For cold-weather starting, press the cold-start but-
ton to declutch the electric traction pump. When
the engine starts, release the button.
6.
When starting the engine for the first time, or
after an engine overhaul, operate the machine in
forward and reverse for one to two minutes. Also
operate the lift lever and the reel drive switch to
be sure all parts operate correctly.
Turn the steering wheel to the left and right to
check steering response. Then shut the engine off
and check for oil leaks, loose parts and any other
noticeable malfunctions.
CAUTION
Shut off the engine and wit for all moving
parts to stop before checking for oil leaks,
loose parts and other malfunctions.
7.
To stop the engine, move the throttle control
downward to IDLE, move the reel drive switch to
DISENGAGE and turn the ignition key to OFF.
Remove the key from the switch and install the
switch cover to prevent accidental starting.
8.
Close the fuel shut-off valves before storing the
machine.
Bleeding The Fuel System
1.
Park the machine on a level surface. Make sure
the fuel tank is at least half full.
DANGER
Because diesel fuel is flammable, use caution
when storing or handling lt.
•
Do not smoke while filling the fuel tank.
•
Do not fill the fuel tank while the engine
is running, hot, or when the machine is in
an enclosed area.
•
Always fill the fuel tank outside and wipe
up any spilled diesel fuel before starting
the engine.
•
Store fuel in a clean, safety-approved con-
tainer and keep the cap in place. Use
diesel fuel for the engine only; not for any
other purpose.
2.
Unlatch and raise the hood.
17
Hide quick links:
Advertisement
Table of Contents
