Automatic Headlamp Mode - Mercedes-Benz AMG GT S Operator's Manual

Hide thumbs Also See for AMG GT S:
Table of Contents

Advertisement

Exterior lighting
86
Exterior lighting
General notes
For reasons of safety, Mercedes-Benz recom-
mends that you drive with the lights switched on
even during the daytime. In some countries,
operation of the headlamps varies due to legal
requirements and self-imposed obligations.
Setting the exterior lighting
Setting options
Exterior lighting can be set using:
the light switch
R
the combination switch (
R
Light switch
Operation
Left-hand standing lamps
1 W
Right-hand standing lamps
2 X
Parking lamps, license plate and
3 T
instrument cluster lighting
Automatic headlamp mode, controlled
4 Ã
by the light sensor
Low-beam/high-beam headlamps
5 L
Rear fog lamp
B R
If you hear a warning tone when you leave the
vehicle, the lights may still be switched on.
Turn the light switch to the à position.
X
The exterior lighting (except the parking/stand-
ing lamps) switches off automatically if you:
switch off the engine with the Start/Stop but-
R
ton
open the driver's door
R
page 87)
Y

Automatic headlamp mode

G
WARNING
When the light switch is set to Ã, the low-
beam headlamps may not be switched on
automatically if there is fog, snow or other
causes of poor visibility due to the weather
conditions such as spray. There is a risk of an
accident.
In such situations, turn the light switch to
L.
The automatic headlamp feature is only an aid.
The driver is responsible for the vehicle's light-
ing at all times.
Canada only:
The daytime running lamps improve the visibility
of your vehicle during the day. The daytime run-
ning lamps function is required by law in Can-
ada. It cannot therefore be deactivated.
When the engine is running and the vehicle is
stationary: if you move the selector lever from a
drive position to P, the daytime running lamps/
low-beam headlamps go out after three
minutes.
When the engine is running, the vehicle is sta-
tionary and in bright ambient light: if you turn the
light switch to the T position, the daytime
running lamps and parking lamps switch on.
If the engine is running and you turn the light
switch to the L position, the manual settings
take precedence over the daytime running
lamps.
USA only:
The daytime running lamps improve the visibility
of your vehicle during the day. To do this, the
daytime running lamps function must be
switched on using the on-board computer
(
page 161).
Y
If the engine is running and you turn the light
switch to the T or L position, the manual
settings take precedence over the daytime run-
ning lamps.
à is the favored light switch setting. The light
setting is automatically selected according to
the brightness of the ambient light (exception:
poor visibility due to weather conditions such as
fog, snow or spray):
If the Start/Stop button is pressed once: the
R
parking lamps are switched on or off auto-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents