Ddc Instructions - Philips M38 107B4 Service Manual

M386 107B4
26
Go to cover page
Step 9: Load DDC data
1. Click from the tool bar.
2. Select the file you want to open as shown in Fig. 20.
3. Click Open .
4. Access "Factory Mode" and enable "Software DDC only" as shown
in Fig. 17 & Fig. 16.
5. Write EDID (click ).
M38107B4
Step 10: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 21.
(EDID Tool 3.01)
Note1 : In User Mode: Read DDC data only
Before read EDID code, please confirm that the
DDC only was disabled
If you do not disable "Software DDC only", when you execute
"read EDID", it will bring up an error message as below.
DDC Instructions (Continued)
Fig. 20
Fig. 21
Software
as shown in Fig. 22.
Fig. 22
Note 2 : In Factory Mode: Read/Write DDC data
Before Read/Write EDID code, please confirm that the
Software DDC only was enabled as shown in Fig. 23.
Fig. 23