Setup The Nvr System - Plustek nvrx880p Quick Manual

Setup the NVR System

To set up the NVR system in your LAN environment:
Please properly configure the IP addresses of the NVR and the IP cameras
before connecting to the Switch. For example, assuming the NVR's IP address is
192.168.10.1, an IP camera's address should range from 192.168.10.2~240.
Attention
1. Connect IP cameras to the Switch's LAN port.
2. Plug the RJ-45 connectors into the NVR's LAN port and the Switch's LAN port.
3. Plug the AC adapter into the DC-Jack of the NVR. Plug the other end of the power cable into a
standard AC power outlet. After the NVR has booted, it will beep three times and the HDD
indicator will blink slowly to indicate that the hard disk has not yet been formatted for use.
Note: If no hard disk is installed when the NVR is powered on, the NVR will beep every 10
seconds and the HDD indicator will blink slowly.
4. Press and hold the "Multi-function" button on the front panel of the device for 3 seconds to begin
the fully automatic setup of the NVR. The hard disk will be formatted first. The HDD indicator will
blink quickly to indicate that the hard disk format is in process.
5. The NVR will beep twice when the format process is finished and the status indicator will blink
quickly. The NVR will now add all available IP-cameras in your network to the NVR
automatically. When the cameras are added, the NVR will reboot, indicated by a long beep.
Note: The IP-cameras need to be in their factory default configuration for automatic setup to
work.
6. Connect a PC or Laptop to the Switch's LAN port.
7. Insert the Installation CD, included with your NVR, into your CD-ROM drive.
3