Table of Contents
Advertisement
•
Do not change the engine governor setting or overspeed
the engine.
•
Raise the tines, stop the machine, and stop the engine
before leaving the operator's position for any reason.
•
Stop the equipment and inspect the tines after striking an
object or if an abnormal vibration occurs. Make necessary
repairs before resuming operation.
•
Keep hands and feet away from the tine area.
•
Never carry passengers and keep pets and bystanders
away.
•
Be alert, slow down, and use caution when making turns.
Look behind and to the side before changing directions.
•
Slow down and use caution when crossing roads and
sidewalks.
•
Do not operate the machine under the influence of
alcohol or drugs.
•
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
•
Use extreme care when loading or unloading the machine
into or out of a trailer or truck.
•
Use care when approaching blind corners, shrubs, trees,
or other objects that may obscure vision.
•
Always be aware of obstacles that may be in the area of
operation. Plan your aeration path to avoid contact with
any obstacle by you or the machine.
Safe Handling of Fuels
•
To avoid personal injury or property damage, use
extreme care in handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other sources
of ignition.
•
Use only an approved fuel container.
•
Never remove fuel cap or add fuel with the engine
running.
•
Allow engine to cool before refueling.
•
Never refuel the machine indoors.
•
Never store the machine or fuel container where there is
an open flame, spark, or pilot light such as on a water
heater or on other appliances.
•
Never fill containers inside a vehicle or on a truck or
trailer bed with a plastic liner. Always place containers on
the ground away from your vehicle before filling.
•
Remove equipment from the truck or trailer and refuel it
on the ground. If this is not possible, then refuel such
equipment with a portable container, rather than from a
fuel dispenser nozzle.
•
Keep the nozzle in contact with the rim of the fuel tank
or container opening at all times until fueling is complete.
•
Do not use a nozzle lock open device.
•
If fuel is spilled on clothing, change clothing immediately.
•
Never overfill fuel tank. Replace fuel cap and tighten
securely.
Slope Operation
•
Do not operate on slopes when grass is wet. Slippery
conditions reduce traction and could cause sliding and
loss of control.
•
Do not make sudden turns or rapid speed changes.
•
Reduce speed and use extreme caution on slopes.
•
Remove or mark obstacles such as rocks, tree limbs,
sprinkler heads, etc. from the operating area. Tall grass
can hide obstacles.
Maintenance and Storage
•
Wait for all movement to stop before adjusting, cleaning,
or repairing. Raise the tines, stop the machine, stop the
engine, and disconnect the spark-plug wire.
•
Clean grass and debris from the tines, drives, muffler, and
engine to help prevent fires. Clean up oil or fuel spillage.
•
Let the engine cool before storing and do not store near
flame.
•
Shut off the fuel while storing or transporting on trailers.
Do not store fuel near flames or drain indoors.
•
Park the machine on level, hard ground. Never allow
untrained personnel to service it.
•
Use jack stands or safety latches to support the machine
when working under it.
•
Remove the spark-plug wire before making any repairs.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Keep all parts in good working condition and all hardware
tightened. Replace all worn or damaged decals.
•
Use only Toro-approved attachments. The warranty
may be voided if the machine is used with unapproved
attachments.
Hauling
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Secure the tines into the transport position with the tine
locking pin before hauling.
•
Use full width ramps for loading machine into trailer or
truck.
•
Tie the machine down securely using straps, chains, cable,
or ropes. Both front and rear straps should be directed
down and outward from the machine.
4
Advertisement
Table of Contents
