Toshiba MD13M1 Service Manual page 14

1-5: AV PCB/DVD PCB/DECK CD (Refer to Fig. 1-5)
1. Make the short circuit on the position as shown Fig. 1-5
using a soldering. If you remove the Deck CD with no
soldering, the Laser may be damaged.
2. Disconnect the following connectors:
(CP8001 and CP8002).
Remove the 4 screws 1.
3.
4. Remove the Deck Angle in the direction of arrow (A).
5. Disconnect the following connectors:
(CP2301, CP2302 and CP2601).
Remove the 4 screws 2.
6.
7. Remove the Deck CD in the direction of arrow (B).
Remove the 4 screws 3.
8.
9. Remove the DVD PCB in the direction of arrow (C).
Remove the 3 screws 4.
10.
11. Remove the AV PCB in the direction of arrow (D).
2
2
Deck CD
3
3
3
1
1
1
AV PCB
Bottom Plate
NOTE
When the installation of the Deck CD, remove all the
soldering on the short circuit position after the connection of
Pick Up PCB and DVD PCB connector.
DISASSEMBLY INSTRUCTIONS
Pick Up PCB
2
2
Make the sort circuit
(B)
using a soldering.
3
DVD PCB
(C)
1
Deck Angle
(A)
4
4
4
(D)
Fig. 1-5
B1-2