Toro 13AX61RH744 Operator's Manual page 29

4. Remove the PTO cable and accompanying spring
from the cutting deck.
5. Remove the deck belt from around the tractor's
engine pulley.
6. Looking at the cutting deck from the left side of the
tractor, locate the deck support pin on the rear left
side of the deck.
7. Pull the deck support pin outward to release the
deck from the deck lift arm. See Figure 25.
Support Pin
Figure 25
8. Repeat the above steps on the tractor's right side.
9. Move the deck lift lever into the top notch to raise
the deck lift arms up and out of the way.
10. Gently slide the cutting deck toward the front of the
tractor allowing the hooks on the deck to release
themselves from the deck stabilizer rod.
11. Gently slide the cutting deck (from the right side)
out from underneath the tractor.
Belt Cover
Changing the Upper Deck Belt
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
IMPORTANT:
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the upper deck belt on your
tractor, proceed as follows:
1. Remove the cutting deck.
2. Remove the belt covers by removing the screws
3. Loosen, but do not remove the deck idler pulleys.
4. Remove the deck belt from around all pulleys,
5. Route the new belt as shown in the figure below
6. Reinstall the belt guards removed earlier and
NOTE:
special tools used in order to change the lower deck
belt. See your Toro dealer to have this belt replaced.
Idler Pulleys
29
WARNING:
Be sure to shut the engine off,
engage the parking brake and remove the
ignition key to prevent unintended starting
before removing the belt.
WARNING:
Avoid the possibility of a
pinching injury. Do not place your fingers on
the idler spring or between the belt and a
pulley while removing the belt.
The V-belts found on your tractor are
that fasten them to the deck. See figure below.
including the deck idler pulleys.
and retighten the deck idler pulleys.
remount the deck to the tractor.
Several components must be removed and
LX465