Sony CDP-CE245 Service Manual page 9

ADJUSTING PHASE OF SWING GEAR AND GEAR (U/D)
Note: Follow the assembly procedure in the numerical order given.
3 Let the swing gear through under the
chassis h and engage its dowel
with the groove
2 Install the rotary encoder so that
its groove comes to the position
f
shown in the figure.
1 Insert the shaft gear up to the
position where its shaft comes
out by 5 mm.
8 screw
7 gear (U/D)
5 stopper washer (FR)
g
of rotary encoder.
f
(PTPWH M2.6)
4 Push fully the shaft of shaft gear and
align the hole shape of gear (loading B).
6 screw
g
f
h
circle mark
swing gear
Fig. A
(PTPWH M2.6)
circle mark
gear (U/D)
gear (RV)
q; screw
(PTPWH M2.6)
9 gear (RV)
Note: Align swing gear, a circle mark
on the gear (U/D), and the teeth
of gear (RV) to the position
showing in the Fig. A.
9