Advertisement
Operation
Playing a Record
It is recommended that you use extreme care when manipulating the tone arm, stylus, and other components of this
turntable. These parts are very sensitive and can easily break or become damaged if they are carelessly handled.
1. Set the Source Dial to Phono.
2. Lift open the turntable dust cover, remove the shroud that protects the stylus, and release the lock that holds
the Tone Arm in place in it's resting position.
3. Select the correct turntable speed based on the type of record you wish to play, and place the record on the
turntable. If you are playing a 45 rpm record, use the included adapter and place it between the turntable
and the record.
33 1/3 rpm
12in diameter
8
Lock
Unlock
78 rpm
45 rpm & adapter
10in diameter
7in diameter
4. Use the Tone Arm Lift Switch to raise the Tone Arm from its catch.
5. Using your hand, gently swing the Tone Arm into the desired location over the record. The turntable will start
spinning as the Tone Arm is moved into position.
6. Use the Tone Arm Lift Switch to safely lower the stylus onto the record.
Using the Lift Switch instead of your hand will reduce the chance of accidentally damaging the record or the stylus.
7. Slide the Auto Stop Switch to ON to enable the Auto Stop feature. When the record is finished playing, it will
automatically stop the turntable. Use the Lift Switch to raise the stylus off of the record, and gently return the
Tone Arm to the catch by hand.
Note: Some records place their Auto Stop area outside of the range of this unit. In these cases, the record will stop
playing before the last track is reached. Set the Auto Stop Switch to OFF and use the Tone Arm Lift Switch to safely
raise the stylus off the record when the end of the record has been reached.
8. When not in use, secure and lock the Tone Arm in its resting position and replace the protective shroud over
the stylus. This will minimize the risk of accidental damage to these sensitive parts.
Customer Support: 1-888-999-4215
9
Advertisement
