Table of Contents
Advertisement
4-2. TEST MODE
■ Continuous run mode
Power on state
(Normal user mode)
Continuous run mode:
1. Press Signal + Dry Level buttons for 3 sec during Power On State (Normal User Mode).
2. Once in Continuous Run Mode, the 7-segment will toggle display "total cycle" and the remaining time.
3. The previous cycle will restart during Continuous Run Mode until continuous run mode is disabled.
4. During Continuous Run Mode, press Signal + Dry Level for 3 seconds to return to normal user mode.
The 7 segment will no long display "total cycle" and only display the remaining time.
■ Special test mode
Definition of special test mode:
•
The dryer must be on before Service Mode can be entered.
•
Press Signal and Temp buttons for 3 seconds, or until 3 beeps are heard.
•
The machine will now be in Service Mode.
•
Upon entry into Service Mode, the Sensor Bar Touch Data will be shown (Default Special Test Mode).
How to enter:
•
To enter Special Test Mode press Signal and Temp Buttons for 3 seconds or until the control beep.
(same for all Frontier models.)
■ Cycle count mode
Definition of cycle count mode:
•
While in Service Mode pressing the Signal button will put the dryer into the cycle count mode
•
Cycle number executed will display.
How to enter:
•
To enter Special test mode, while in service mode, press the signal button until the control beep. (same for all Frontier
models.)
■ Software version mode
Definition of software version mode:
•
While in Service Mode pressing the Temp button will put the dryer into the software version mode
How to enter:
•
To enter Special Test Mode press Temp Button until the control beep. (same for all Frontier models.)
ex) In case of "U105", U0 means major version "v1" 05 means minor version "05"
Signal + Dry level (3 sec.)
Continuous run mode
Troubleshooting _ 25
Hide quick links:
Advertisement
Table of Contents
