Remote Control; Connecting The Power Cord - Onkyo HT-S590 Instruction Manual

Connecting Your Components—Continued
Connecting Onkyo
Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable.
Step 2: Make the
connection.
Step 3: If you're using an MD, CDR, or HDD component, change the input Display (see page 35).
With (Remote Interactive), you can use the following special functions:
■ Auto Power On/Standby
When you start playback on a component connected via
turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all compo-
nents connected via
■ Direct Change
When playback is started on a component connected via
as the input source. If your DVD player is connected to the AV receiver's multichannel DVD input, you'll need to
press the [MULTI CH] button to hear all channels (see page 37), as the Direct Change
FRONT DVD IN jacks.

■ Remote Control

You can use the AV receiver's remote controller to control your other
remote controller at the AV receiver's remote control sensor instead of the component.
Notes:
• Use only cables for
cables are supplied with Onkyo players (DVD,
CD, etc.).
• Some components have two
connect either one to the AV receiver. The other
jack is for connecting additional
components.
• Connect only Onkyo components to
Connecting other manufacturer's components
may cause a malfunction.
• Some components may not support all
tions. Refer to the manuals supplied with your
other Onkyo components.

Connecting the Power Cord

Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Connect the AV receiver's power cord to a suitable wall outlet.
• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.
Components
will also go on Standby.
connections.
jacks. You can
-capable
jacks.
func-
, if the AV receiver is on Standby, it will automatically
, the AV receiver automatically selects that component
-capable Onkyo components, pointing the
REMOTE
CONTROL
e.g., CD player
e.g., DVD player
function only selects the
IN
L
R
CD
FRONT
L
R
DVD
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
33