Table of Contents
Advertisement
Operate the machine with the engine speed set at slow or
medium when learning how to use the controls. Practice
driving the machine in a level open area.
Ground Speed
1. Place the quick release levers in the unlock position
(Fig. 14).
2. Move the reference bar forward or backward to set the
desired forward speed. The pointer indicates
approximate ground speed. When the bar is in the full
forward position the ground speed is approximately
6.5 mph. When the reference bar is in the middle
position the ground speed is approximately 3 mph.
Note: In normal conditions, a 2.5 to 3.5 mph ground speed
(middle position of the reference bar) is best for cutting
performance. Use a faster ground speed for light cutting or
transport. Use a slower ground speed in heavy cutting
loads.
3. Place the quick release levers in the lock position
(Fig. 14).
Forward
1. To go forward, slowly press on the upper control bar
against the reference bar (Fig. 14).
2. To go straight, apply equal pressure to both ends of the
upper control bar (Fig. 14).
3. To turn, release pressure on the upper control bar side
toward the direction you want to turn (Fig. 14).
4. Adjust reference bar to maintain a comfortable pre-set
ground speed (Fig. 14).
5. To stop, release the upper control bar to stop both
wheels (Fig. 14).
Note: If the front of the deck lifts off the ground when the
upper control bar is quickly pushed forward or the
machine is unable to drive uphill, an adjustment may be
needed. Refer to: Adjusting By-pass Valve.
1
2
Figure 14
1. Upper control bar
2. Reference control bar
Backward
1. To go backward, slowly pull the upper control bar
rearward (Fig. 14).
2. To go straight, apply equal pressure to both ends of the
upper control bar (Fig. 14).
3. To turn, release pressure on the upper control bar side
away from the direction you want to turn (Fig. 14).
4. To stop, release the upper control bar to stop both
wheels (Fig. 14).
Bringing Machine to Neutral
Position
Release the upper control bar to stop. The machine will
automatically return to neutral. When in neutral, the
hydrostatic drive system will provide dynamic braking so
the machine will not roll.
Note: Very slow drive motion with engine running and the
control in neutral is normal. Excessive drive motion when
the control is in neutral may indicate adjustment is
needed. Refer to: Adjusting Neutral procedure.
Stopping the Machine
1. To stop, release the upper control bar to stop both
wheels (Fig. 14).
2. Release the blade control bail (PTO), to stop the
mower blades. Move the engine speed throttle control
to "SLOW".
3. Turn the ignition key to "OFF" to stop the engine.
Remember to remove the key from the ignition switch.
Important
If the machine is on a slope, set the parking
brake to prevent the machine from slowly rolling.
21
3
m–5187
3. Quick release lever
(locked position)
Advertisement
Table of Contents
